Linux version 2.4.19-xfs-devfs (root@clover) (gcc version 2.95.4 20011002 (Debian prerelease)) #8 Tue Nov 12 11:10:17 PST 2002
BIOS-provided physical RAM map:
 BIOS-e820: 0000000000000000 - 000000000009c000 (usable)
 BIOS-e820: 000000000009c000 - 00000000000a0000 (reserved)
 BIOS-e820: 00000000000e7400 - 0000000000100000 (reserved)
 BIOS-e820: 0000000000100000 - 000000000efe0000 (usable)
 BIOS-e820: 000000000efe0000 - 000000000efefc00 (ACPI data)
 BIOS-e820: 000000000efefc00 - 000000000eff0000 (ACPI NVS)
 BIOS-e820: 000000000eff0000 - 000000000f100000 (reserved)
 BIOS-e820: 00000000fff00000 - 0000000100000000 (reserved)
239MB LOWMEM available.
Advanced speculative caching feature not present
On node 0 totalpages: 61408
zone(0): 4096 pages.
zone(1): 57312 pages.
zone(2): 0 pages.
Kernel command line: root=/dev/hda4 vga=0x0314
Initializing CPU#0
Detected 859.298 MHz processor.
Console: colour dummy device 80x25
Calibrating delay loop... 1710.48 BogoMIPS
Memory: 240384k/245632k available (1410k kernel code, 4848k reserved, 447k data, 104k init, 0k highmem)
Dentry cache hash table entries: 32768 (order: 6, 262144 bytes)
Inode cache hash table entries: 16384 (order: 5, 131072 bytes)
Mount-cache hash table entries: 4096 (order: 3, 32768 bytes)
Buffer-cache hash table entries: 16384 (order: 4, 65536 bytes)
Page-cache hash table entries: 65536 (order: 6, 262144 bytes)
CPU: Before vendor init, caps: 0084893f 0081813f 0000004e, vendor = 7
CPU: L1 I Cache: 64K (64 bytes/line), D cache 64K (32 bytes/line)
CPU: L2 Cache: 512K (128 bytes/line)
CPU: Processor revision 1.4.1.0, 867 MHz
CPU: Code Morphing Software revision 4.3.0-9-197
CPU: 20020207 23:55 official release 4.3.0#7
CPU: After vendor init, caps: 0084893f 0081813f 0000004e 00000000
CPU serial number disabled.
CPU:     After generic, caps: 0080893f 0081813f 0000004e 00000000
CPU:             Common caps: 0080893f 0081813f 0000004e 00000000
CPU: Transmeta(tm) Crusoe(tm) Processor TM5800 stepping 03
Checking 'hlt' instruction... OK.
POSIX conformance testing by UNIFIX
mtrr: v1.40 (20010327) Richard Gooch (rgooch@atnf.csiro.au)
mtrr: detected mtrr type: none
PCI: PCI BIOS revision 2.10 entry at 0xfd88e, last bus=1
PCI: Using configuration type 1
PCI: Probing PCI hardware
PCI: Using IRQ router ALI [10b9/1533] at 00:07.0
Linux NET4.0 for Linux 2.4
Based upon Swansea University Computer Society NET3.039
Initializing RT netlink socket
apm: BIOS version 1.2 Flags 0x03 (Driver version 1.16)
Starting kswapd
devfs: v1.12a (20020514) Richard Gooch (rgooch@atnf.csiro.au)
devfs: boot_options: 0x1
SGI XFS snapshot 2.4.19-2002-09-27_04:22_UTC with ACLs, quota, no debug enabled
vesafb: framebuffer at 0xfd000000, mapped to 0xcf800000, size 8192k
vesafb: mode is 800x600x16, linelength=1600, pages=7
vesafb: protected mode interface info at c000:50e4
vesafb: scrolling: redraw
vesafb: directcolor: size=0:5:6:5, shift=0:11:5:0
Console: switching to colour frame buffer device 100x37
fb0: VESA VGA frame buffer device
pty: 256 Unix98 ptys configured
Serial driver version 5.05c (2001-07-08) with MANY_PORTS SHARE_IRQ SERIAL_PCI enabled
Uniform Multi-Platform E-IDE driver Revision: 6.31
ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx
ALI15X3: IDE controller on PCI bus 00 dev 78
PCI: No IRQ known for interrupt pin A of device 00:0f.0. Please try using pci=biosirq.
ALI15X3: chipset revision 195
ALI15X3: not 100% native mode: will probe irqs later
    ide0: BM-DMA at 0x1800-0x1807, BIOS settings: hda:DMA, hdb:pio
    ide1: BM-DMA at 0x1808-0x180f, BIOS settings: hdc:DMA, hdd:pio
hda: TOSHIBA MK2018GAP, ATA DISK drive
ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx
hdc: TOSHIBA DVD-ROM SD-R2102, ATAPI CD/DVD-ROM drive
ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
ide1 at 0x170-0x177,0x376 on irq 15
hda: 39070080 sectors (20004 MB), CHS=2432/255/63, UDMA(66)
Partition check:
 /dev/ide/host0/bus0/target0/lun0: p1 p2 p3 p4
floppy0: no floppy controllers found
RAMDISK driver initialized: 16 RAM disks of 4096K size 1024 blocksize
Linux agpgart interface v0.99 (c) Jeff Hartmann
agpgart: Maximum main memory to use for agp memory: 189M
agpgart: no supported devices found.
Linux Kernel Card Services 3.1.22
  options:  [pci] [cardbus] [pm]
PCI: Found IRQ 9 for device 00:0c.0
Intel PCIC probe: not found.
usb.c: registered new driver usbdevfs
usb.c: registered new driver hub
Yenta IRQ list 0cf8, PCI irq9
Socket status: 30000006
NET4: Linux TCP/IP 1.0 for NET4.0
IP Protocols: ICMP, UDP, TCP, IGMP
IP: routing cache hash table of 2048 buckets, 16Kbytes
TCP: Hash tables configured (established 16384 bind 16384)
ip_conntrack (1919 buckets, 15352 max)
ip_tables: (C) 2000-2002 Netfilter core team
NET4: Unix domain sockets 1.0/SMP for Linux NET4.0.
XFS mounting filesystem ide0(3,4)
VFS: Mounted root (xfs filesystem) readonly.
Mounted devfs on /dev
Freeing unused kernel memory: 104k freed
Adding Swap: 498004k swap-space (priority -1)
SCSI subsystem driver Revision: 1.00
scsi0 : SCSI host adapter emulation for IDE ATAPI devices
  Vendor: TOSHIBA   Model: DVD-ROM SD-R2102  Rev: 1G15
  Type:   CD-ROM                             ANSI SCSI revision: 02
8139too Fast Ethernet driver 0.9.25
PCI: Found IRQ 9 for device 00:10.0
eth0: RealTek RTL8139 Fast Ethernet at 0xd0071800, 00:e0:00:ae:91:07, IRQ 9
eth0:  Identified 8139 chip type 'RTL-8139C'
PCI: Found IRQ 11 for device 00:02.0
usb-ohci.c: USB OHCI at membase 0xd0079000, IRQ 11
usb-ohci.c: usb-00:02.0, Acer Laboratories Inc. [ALi] USB 1.1 Controller
usb.c: new USB bus registered, assigned bus number 1
hub.c: USB hub found
hub.c: 2 ports detected
Initializing USB Mass Storage driver...
usb.c: registered new driver usb-storage
USB Mass Storage support registered.
usb.c: registered new driver keyboard
usbkbd.c: :USB HID Boot Protocol keyboard driver
usb.c: registered new driver usb_mouse
usbmouse.c: v1.6:USB HID Boot Protocol mouse driver
mice: PS/2 mouse device common for all mice
Trident 4DWave/SiS 7018/ALi 5451,Tvia CyberPro 5050 PCI Audio, version 0.14.9d, 11:23:00 Nov 12 2002
PCI: Found IRQ 9 for device 00:04.0
trident: ALi Audio Accelerator found at IO 0x1000, IRQ 9
ac97_codec: AC97 Audio codec, id: 0x8384:0x7656 (SigmaTel STAC9756/57)
eth0: Setting 100mbps full-duplex based on auto-negotiated partner ability 45e1.